Ordering 0.64 and 0.6

A payroll clerk needs to compare two hourly rate adjustments, $0.5 and $0.48, to determine which is the higher increase. Arrange the steps of the standard decimal comparison procedure in the correct order to perform this task.

A logistics manager is comparing the weights of two shipping containers to ensure they meet safety standards. The weights are recorded as 12.5 tons and 12.48 tons. According to the standard procedure for ordering decimals, what is the primary reason for writing 12.5 as 12.50 before comparing?

A machinist is comparing two precision measurements for a mechanical part: 0.375 inches and 0.38 inches. To determine which is larger, the machinist uses the standard procedure for ordering decimals. Match each step of the procedure with the correct description of the action taken during that step.

A machinist is comparing two precision measurements: 0.5 inches and 0.48 inches. According to the standard procedure for ordering decimals, the machinist should add a(n) ________ zero to 0.5 so that both numbers have the same number of decimal places before the comparison is made.

Comparing Hourly Wage Increases

Fuel Efficiency Audit

A laboratory technician is using the standard four-step procedure for ordering decimals to compare two concentration levels. According to this procedure, once the decimal points are aligned and the number of decimal places is equalized, the technician should compare the digit sequences as if they were whole numbers.

Documenting the Standard Procedure for Decimal Comparison

A financial analyst is comparing two interest rates, 0.06 and 0.058, using the standard four-step procedure for ordering decimals. After equalizing the decimal places (comparing 0.060 and 0.058), the analyst compares the numbers as if they were whole numbers (60 and 58). According to the procedure, this whole-number comparison is valid because both decimals now share the same:

A pharmacy technician is using the standard four-step procedure for ordering decimals to compare two liquid dosages: 0.6 mL and 0.58 mL. After aligning the decimal points and equalizing the number of decimal places, which pair of whole numbers will the technician compare in the third step to determine the larger dosage?